Auto Off: how it works and which timings to set

Find out which products support Auto Off, the timings from 100 ms to 1 hour and how to configure it in Freedompro Home.

Usare Freedompro Home 1 min read

Auto Off automatically turns off an output after the configured time.

In short: it is available for lights, outlets, and dry contacts, it is disabled by default, and it can be set from 100 ms to 1 hour.

Supported products

  • LB light modules.
  • OL outlet modules.
  • SW dry contact modules.

Available range

Parameter Value
Minimum 100 ms
Maximum 1 hour
Available units Milliseconds, seconds, and minutes
Initial setting Disabled

How to configure it

  1. Open Freedompro Home.
  2. Select the accessory.
  3. Open Settings.
  4. Select Auto Off.
  5. Enable the function.
  6. Set the duration.
  7. Save and verify the behavior.

Examples

Use Guidance
Gate or garage door Use the time required by the control unit to simulate a pulse
Timed light Automatically turns the light off after the configured time
Outlet Stops the load after the set duration

The correct duration depends on the connected equipment. For gates, boilers, and control units, always use the value specified by the manufacturer.

Auto Off and power outage

Auto Off and Default state are separate settings. After a restart, you can choose Keep, Off, or On; the default value is Keep previous state.